[quote=“magu”][quote=“2stimpy”]I am now waiting for the bed t reach 110c, i have been sitting here now for 30 minutes and its at 103c.
I doubt if i reach the 110c.
So i need to upgrade the bed even more with a new heated plate, and a new power supply.
This simply can’t handle the job.[/quote]
Are you using the 100 W MeanWell supply? I get my stock K8200 bed up to at least 115 C with my 320 W supply on 24 V (in a cabinet). You might be maxing out the supply.
Changing the PCB bed to one with proper support for 24 V will of course make it easier to reach higher temps. Even more so by getting the M3a alu bed and using the 12 V terminals with 24 V (as instructed by the supplier); which supposedly makes it possible to reach more than 100 C in about 2 minutes.[/quote]
Jip, using the 100 w power supply.
I am also thinking about installing a new heatbed, but i think this also means buying a new power supply because than 4,5 amp is not enough i think.
As you can see in my other post, i also have my printer in a box.(still need to fit the door though.