[quote=“svdv”]I don’t think you have to customize Marlin and even the flowrate is the same as with the original printhead.
Have you cleaned the printhead and checked for obstructions in the heatbreak?
If taken off the nozzle, can you push the filament through from the extruders site by hand?
And if the nozzle is hot (PLA around 200 degrees) can you push filament through by hand?
Be aware the fan is on all the time on 100%, not only when printing. I connected the fan directly to the PSU (with a resistor in between) to get the fan always on.[/quote]
I clean the nozzle and look for obstructions and it looks very well.
I can push the filament through by hand and it give not any problem.
When i heat the nozzle about 190 degrees the filament is coming out no problem.
Today i placed the orginale tube from velleman and while printing the tube came lose from the printerhead.
Strange, veru strange isn’t?
When i placed the tube from the e3dv6 then clutch the printerhead.
I see that you come from the nertherlands is there a way that we can speak dutch by mail or something, my english is not so good