Our first 3D-printing experience is having some difficulties. The assamblage was very clear, but while testprinting there’s almost no fillament comming out the nozzle. The little bit of filament coming out, curls in the air. Here a video about it.
Calibration is OK, red led on the trimmer is blinking on touching the bed, so everything seems OK, apart from the filament. We use ABS 1.75
What we already tried:
- loosen the screws above where the filament is pushed
- unloading and reloading the fillament
- manually reloading the fillament
Now we’re out of ideas. Anyone does recognize this problem?