the K8200 here has been connected properly. All steps in the instruction manual beforehand were done in correct order and everything is fine but when I pull the heated bed forward and push the HOME Y AXIS button on Repetier the board moves further forward although it should move backwards.
I checked the wiring, everything has been connected correctly. What could be the cause of the malfunction? I found this old thread viewtopic.php?f=1&t=12200 but I do not quite understand the solution of the OP.
The Y motor moves in the correct directions according the instruction manual. I’m not that fluent in electronics so I do not know where the cause of this problem might be.