My assembly problems and solutions - Delta


#1

After finished the assembly of Vertex Delta I had a lot of calibration problems. The nozzle dived into the buildtak on every calibration. Then I remembered that I did turn the calibration sensor knob, on the backside, before unpacking the Delta. So I turned the calibration sensor knob a few turns anti-clockwise and tried again to print. After this I have not had any problems whatsoever to calibrate and print. This Delta machine is the third 3D printer I owned and I like it best of them all! It is an outstanding construction!
BR, Ulf Soderback


#2

Great to hear you love the machine!