Problem with BRIM

Hi folks,

since a few days i notice this strange problem while printing a brim: the lines to not touch each other! And it looks like the space in between is increasing. It isn’t a faulty setting, i did not change that. Also, first layer extrusion is at 300%.
But the rest of the print is okay and al the measurements are oke, or …
Can it be a burned stepper driver? If yes, why are all the other layers printed oke then?! Or doesn’t it have to do anything with that?

Kind regards,

Hello Almer,

Can you upload a picture of it (problem). So we can check / help you further.
Now it’s difficult to say where problem is situated, without seeing the problem.

Als take a picture of just the first layer that’s is printed

Velleman support